Manufacturer page.

Penguard WF is a two component water borne epoxy coating for corrosion protection. It is a versatile, fast drying product containing flash rust inhibitors. It cures down to 41 °F (5 °C). The declared product is specially designed for new construction where short dry to handle and over coating times are required. It can be used as primer, mid coat, finish coat or as single coat system in atmospheric environments. This product is suitable for properly prepared carbon steel, aluminum, concrete and galvanized steel substrates. Penguard WF is suitable for structural steel and piping to be exposed to corrosive environments up to high, and is recommended for offshore environments, refineries, power plants, bridges, buildings and mining equipment. It is suitable for over coating with water borne acrylics, water borne epoxy and suitable solvent borne coatings. Product mixing ratio (by volume: Penguard WF Comp A: 2 parts Penguard WF Comp B: 1 part Density: 1.3 kg/l Solids by volume: 51 ± 2 % Dry film thickness: 75-150 μm Wet film thickness: 145-295 μm Theoretical spreading rate: 6.8-3.4 m2/l The most representative and worst case formulation produced at the manufacturing site is chosen for this EPD. For products with a selection of colours, this will be the formulation with the highest content of titanium dioxide. The product packaging is based on an average sized metal packaging, including secondary packaging such as pallets and plastic wrapping. For safety, health and environmental conditions, see the Safety Data Sheet for the declared product on www.jotun.com. For information on technical data, application and use of the product, see the Technical Data Sheet and Application Guide for the declared product on www.jotun.com.