Manufacturer page.

Penguard Express ZP E is a two component amine cured epoxy coating. This product is LEED compliant and contains no solvents on the Hazardous Air Pollutants (HAPs) list. It is a fast drying, zinc phosphate pigmented, high solids, high build product. This product is specially designed for new construction where short dry to handle and over coating times are required. The declared product can be used as primer, mid coat, finish coat or as single coat system in atmospheric environments, and is suitable for properly prepared carbon steel substrates. It can be applied at sub zero surface temperatures. It is suitable for structural steel and piping to be exposed to highly corrosive environments, C5I or C5M (ISO 12944-2), and is recommended for offshore environments, refineries, power plants, bridges, buildings and mining equipment. Product mixing ratio by (volume): Penguard Express ZP E Comp A: 4 parts Penguard Express E Comp B: 1 part Density: 1.6 g/cm³ Solids by volume: 75 ± 2 % Dry film thickness: 75-250 μm Wet film thickness: 100-335 μm Theoretical spreading rate: 10-3 m2/l The most representative and worst case formulation produced at the manufacturing site is chosen for this EPD. For products with a selection of colours, this will be the formulation with the highest content of titanium dioxide. The product packaging is based on an average sized metal packaging, including secondary packaging such as pallets and plastic wrapping. For safety, health and environmental conditions, see the Safety Data Sheet for the declared product on www.jotun.com. For information on technical data, application and use of the product, see the Technical Data Sheet and Application Guide for the declared product on www.jotun.com.